I have two Juniper EX3400 switches that support layer 3 routing as well. I want to create a layer 3 routing on one switch and want to use a second switch as an access switch. Both switches are connected via fiber link, both uplink ports are set in trunk mode with the blue vlan allowed on both switches.
On switch 1, if I add any port in access mode and allow the blue vlan it will automatically assign IP address to the connected devices (such as 10.0.0.6). But on the second switch (SW2) is not directly getting the IP address from the first switch although three-ports is set in access mode and theoretically it should be getting IP addresses 10.0.0.2, 10.0.0.3, 10.0.0.4 respectively.
Here are the configuration details. Please tell me is there anything else that needed to be on switch two to make things work. Is layer 3 trunking is different...
